1.3''-LCD-Breakout

1.3inch LCD Breakout

1.3” LCD breakout is a 1.3-inch diagonal display with 240 x 240 resolution, 65K RGB colors, clear and colorful displaying effect, Four Push buttons, and a joystick. The 1.3" LCD breakout includes an integrated ST7789VM display driver and SPI interface, reducing the number of IO pins required.

Features

• 1.3inch diagonal, 240x240 resolution, with embedded controller, communicating via SPI interface.
• SPI interface, requires minimum GPIO for controlling.
• Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/ Arduino/STM32).

Specifications

• Operating Voltage - 3.3 V
• Pixels - 240x240 resolution
• Pixel Size - 0.0975 (H) x 0.0975 (V) mm
• Display Driver - ST7789VM
• Display Color - 65K RGB

Buy it From : Click Here

Installation

• 1.3inch LCD breakout Module for microcontrollers eg: Raspberry Pi, Arduino, and raspberry pi pico, etc. it has, 65K Colors, 240×240, supports SPI protocol

In this folder, you see two python files and one firmware.uf2 file

• st7789.py -> this file contain the library of the LCD module, save the file in the raspberry pi pico
• main.py -> this file contain the main code, you need to run this file, you also need to save this file to Pico
• firmware.uf2 -> by pressing bootsel of the pico and hold then connect to the laptop after this a new storage device comes, name "RPI-RP2", then drag and drop this file to pico

For setup the Board in thonny

• Stack Raspberry Pi Pico on the female header of Pico Sense HAT.
• Connect USB cable on Raspberry Pi Pico USB port.
• Choose interpreter as MicroPython (Raspberry Pi Pico).

Resources

Github

• Source Code