Air-Monitoring-HAT

Air Monitoring HAT (Incomplete Wiki)

Air Monitoring HAT is a powerful and hi-tech PMSA003 sensor that provides the information of suspended particulate matter (PM1.0, PM2.5, and PM10) in the air per unit volume via digital output with an operating voltage of 3.3 V. It communicates via UART (serial) with the standby current ≤200 Microampere (μA) of the sensor.

Features

• Digital sensor
• Operating Voltage 5V DC
• PMSA003 Sensor
• Standard 40 Pin GPIO
• OLED Display 0.91”
• Measuring range 0.3 to 10 Micron
• UART (Serial) Interface

Specifications

• Model - Air Monitoring HAT
• Sensor Model number - PMSA003
• Data Output - Digital Sensor(unit quality + number of units)
• Type - Biosensor
• Communication Interface - UART (Serial)
• Display Type - OLED Display 0.91”
• Board Dimension - 65 x 56 mm
• Measuring range - 0.3 to 1.0, 1.0 to 2.5, 2.5 to 10 Micron (μm)
• Counting efficiency - 50% @ 0.3 μm 98% @> = 0.5 um
• Response time - ≤10 s
• DC supply voltage - 5.0 V
• Maximum Operating Current - 100 Milliamp (mA)
• Standby current - ≤200 Microamp (μA)
• Data interface level - L <0.8 @3.3, H >2.7@3.3 Volt(V)
• Operating Temperature range - -10 to +60 Celsius (℃)
• Operating Humidity range - 0 - 99%
• Mean time between failures - ≥3 Year(Y)

File:Air monitoring hat.png

Buy it From : Click Here

Pinout

Board Pins	Raspberry Pi
5V	5V
GND	GND
PMS RX	GPIO 14
PMS TX	GPIO 15
PMS SET	GPIO 27
PMS RESET	GPIO 17
OLED SDA	GPIO 2
OLED SCL	GPIO 3

Installation

Python

Required Hardware

• Raspberry Pi x 1
• Air Monitoring HAT x 1

Enable I2C and Serial Interface

• Open a terminal and run the following commands to enable I2C：

sudo raspi-config

Choose Interfacing Options -> I2C ->yes

• Again run below command to enable Serial

sudo raspi-config

Choose Interfacing Options -> Serial -> No -> Yes

• You can also enable Serial and I2C using Graphical method, Open Menu by clicking on Raspberry Pi icon >> Preferences >> Raspberry Pi Configurations >> Interfaces , and select below option.

• Now reboot your pi by running the below command :

sudo reboot