Difference between revisions of "Pi-motor-driver-hat"
From SB-Components Wiki
| Line 41: | Line 41: | ||
* Connect peripherals with Motor driver HAT as shown in below circuit diagram and turn on slider switch to turn on the Raspberry Pi. | * Connect peripherals with Motor driver HAT as shown in below circuit diagram and turn on slider switch to turn on the Raspberry Pi. | ||
| − | [[File: | + | [[File:Motor_driver_hat_ckt.png]] |
* Now open the terminal and run the below command to clone the Github repository of Motor driver HAT. | * Now open the terminal and run the below command to clone the Github repository of Motor driver HAT. | ||
Revision as of 06:39, 28 June 2021
Raspberry Pi Motor Driver HAT (Installation pending)
Motor Driver HAT for Raspberry Pi is a module designed to control 2 DC motors simultaneously with I2C communication. It has a powerful onboard chip PCA9685 which provides 12-bit hardware PWM to adjust the motor speed. The logic voltage is 3.3 V with the motor driver TB6612FNG. It can be powered from a battery through the VIN terminal which makes a better experience for the user.
Features
- Standard Raspberry Pi 40 Pin GPIO Extension Header
- 5V Regulator
- Current up to 3A
- I2C Control Interface with 5 address jumper
- I2C Controller Pins
- 12-bit hardware PWM For Speed Adjustment of Motor
- Control 2 DC Motor Simultaneously
Specifications
- Logic voltage: 3.3V
- Power supply: 6V~12V (VIN terminal)
- PWM driver: PCA9685
- Motor driver: TB6612FNG
- Control interface: I2C
File:Pi motor driver HAT.png
Buy it From : [ Click Here]
Pinout
| Motor Driver HAT | BCM |
|---|---|
| VCC | 5V |
| GND | GND |
| SDA | GPIO 2 |
| SCL | GPIO 3 |
Installation
- Stack Motor driver HAT on Raspberry Pi 40 Pin header.
- Connect peripherals with Motor driver HAT as shown in below circuit diagram and turn on slider switch to turn on the Raspberry Pi.
- Now open the terminal and run the below command to clone the Github repository of Motor driver HAT.
git clone https://github.com/sbcshop/Motor-Driver-HAT.git
- Now enter the downloaded folder by running the below command
cd Motor-Driver-HAT
- Now run the "Demo.py" python file by running the below command to move motors.
python3 Demo.py
Resources
Github
Datasheet