Home-Automation-HAT

Home Automation HAT

Home Automation HAT is a Home monitoring and automation controller HAT for the Raspberry Pi that can control up to 2 appliances/devices on a load of 250 VAC/7A, 30 VDC/10A, photo-coupling isolation Optocoupler EL357NC, allowing users to safely control high voltages or current devices. Home-Automation HAT makes appliances smart, which users can operate via the PiRelay app on their electronic device.

Features

• Compatible with Raspberry Pi 4, 3B+,3,2,Zero
• Relay Status Indicator
• Comes With Development Resources, including examples in Python
• COM, NO(Normally Open) & NC(Normally Closed) are available for each relay
• Connectivity of Relay With RPi Without GPIO
• Connectivity Using Stack Method
• Onboard Power LED Indicator
• Make Your Home IoT Enabled
• Relay Control Pins Selection Jumper

Specifications

• Operating Voltage - 220V AC (Via Terminal Block)
• External Load - 250 VAC/7A, 30 VDC/10A
• Relay Channels - 2
• Trigger Signal - 3.3/5V
• Optocoupler - (CTR: 50~600% at IF= 5mA, VCE = 5V)
• External Power Supply - Via Terminal Block
• GPIO - 40 Pins Stacking Header
• Load Connector - Screw Terminal Block for each Relay(Output)

File:Home-auto-hat.png

Buy it From : [ Click Here]

Pinout

Relays	BOARD	BCM
Relay 1	35	GPIO 19
Relay 2	33	GPIO 13

Installation

Raspberry Pi (Using PiRelay App)

PiRelay is an Android app you can use to Switch or Pulse the GPIO Pins of a Raspberry Pi connected to Relays. To use this app you will need to setup your Raspberry Pi and Relays. App Download link:

• To setup PiRelay on Raspberry Pi, run the below commands one by one. Must complete all commands to make it work with Raspberry Pi.

Commands to Install: WiringPi, Apache, PHP & Download the GPIO PHP File

sudo apt-get update

sudo apt-get install wiringpi apache2 libapache2-mod-php -y

sudo wget https://pirelay.jasonfindlay.com/downloads/gpio.dl

sudo mv gpio.dl /var/www/html/gpio.php

Setting Up Your Android Device

Resources

Github

• Source Code