Pi-servo-HAT

Raspberry Pi Servo HAT

16 Channel Servo Driver HAT for Raspberry Pi is a motor driver HAT from which one can control up to 16 motors simultaneously. If you're building a robot with a lot of moving parts, or if you need to monitor a lot of servo motors with PWM yields, the microcontroller's limited PWM yields will be a big problem. The most important thing you can do to solve this problem is to obtain a 16-Channel 12-Bit PWM/Servo Driver.

Features

• Adjustable frequency PWM up to about 1.6 kHz
• Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales)
• 3 pin connectors in groups of 4 so you can plug in 16 servos at once
• This board/chip uses an I2C 7-bit address
• 40-Pin GPIO accessibility
• I2C controlled and power supply connector
• Compatible with all the Raspberry Pi Models such as 4B, 3B+, 3, 2, B+, A, Zero, Zero W, etc.

Specifications

• Power supply: 5V OR 6V (power supply connector)
• Servo voltage: 5V
• Logic voltage: 3.3V
• Driver: PCA9685
• Control interface: I2C/GPIO

Buy it From : Click Here

Pinout

Motor Driver HAT	BCM
VCC	5V
GND	GND
SDA	GPIO 2
SCL	GPIO 3

Installation

Python

• Stack Servo HAT on Raspberry Pi.

• Now connect the external power supply of 6V - 12V DC on the Green connector as shown below, Turn on the adapter and it will power the Raspberry Pi.

• Now connect Servo motor on any servo port ranging between 0-15.

• Clone Github repository by running below command in terminal.

https://github.com/sbcshop/Raspberry-Pi-Servo-Driver.git

• It will clone the repository in the '/home/pi' location, To enter cloned repository, enter the below command.

cd Raspberry-Pi-Servo-Driver

• Now run the below command to execute the python code.

sudo python3 servo_controller.py

• If you are using any other pin (between 0-15) then change the default servo pin to the designated pin in code i.e controller.Set_Pulse(15,i)