Pico-wifi-HAT

Pico Wi-Fi HAT (Incomplete Wiki)

Pico Wi-Fi HAT is a compact and easy-to-use Wi-Fi HAT for the Raspberry Pi Pico that includes an ESP8266 module, IEEE 802.11b/g/n Wi-Fi Standard, 3.3 V Operating Voltage, UART Communication interface, and a 40-pin GPIO extension header that can be controlled via AT Command and supports TCP/UDP communication protocol.

Pico Wi-Fi HAT also includes a 1.14-inch display with a resolution of 240 x 135 pixels, 65K RGB colors, and a sharp and vivid exhibiting effect, designed primarily for user engagement via SPI connection by incorporating a GPIO header. The 1.14-inch LCD includes the ST7789 Driver and SPI Interface, decreasing the amount of IO pins required.

It's a simple way to enable Wi-Fi on the Raspberry Pi Pico, making it suitable for a variety of IoT communication projects. It is intended for developers of all skill levels, from the most experienced to those who are just getting started with IoT devices.

Features

ESP8266 module with four-layers process
Standard Raspberry Pi Pico 40-pin GPIO extension header
Supports STA, AP, and STA+AP three Wi-Fi operating modes, embedded LWIP protocol stack, supports TCP/UDP communication
2x functional buttons
Comes with development resources and manual

Specifications

Operating Voltage - 3.3 V (Internally connected on Pico 3v3 pin)
Communication - UART Interface
UART BAUD RATE - 115200 bps
Wi-Fi Standard - IEEE 802.11b/g/n
Frequency Range - 2400 ~ 2483.5 MHz
Wi-Fi Operating Mode - Wi-Fi STA, Wi-Fi AP, Wi-Fi STA+AP
Protocol - TCP, UDP
Antenna - PCB Antenna
Operating Temperature - -40℃ ~ 85℃

File:Pico wifi HAT.png

Buy it From : Click Here

Pinout

Installation

MicroPython

Stack Pico Wi-Fi HAT with Raspberry Pi Pico.

Now Run Hercules Setup Utility and select tab TCP Server, enter port number as 8080 (you can choose any other port as well) and finally click on Listen button to start the TCP server on your PC/Laptop. Note down your PC/Laptop IP address to access your TCP Server.

Make sure to connect your PC/Laptop and Pico Wi-Fi HAT on same router. For example: If your Wi-Fi SSID is "TEST" and password is "test1234", then you must connect both device on TEST network.

Resources