Difference between revisions of "1.3''-LCD-Breakout"

From SB-Components Wiki

Line 24: Line 24:
  
 
== Installation ==
 
== Installation ==
===USB Setup===
 
  
 +
* 1.3inch LCD breakout Module for microcontrollers eg: Raspberry Pi, Arduino, and raspberry pi pico, etc. it has, 65K Colors, 240×240, supports SPI protocol
 +
 +
In this folder, you see two python files and one firmware.uf2 file
 +
* st7789.py -> this file contain the library of the LCD module, save the file in the raspberry pi pico
 +
* main.py  -> this file contain the main code, you need to run this file, you also need to save this file to Pico
 +
* firmware.uf2 -> by pressing bootsel of the pico and hold then connect to the laptop after this a new storage device comes, name "RPI-RP2", then  drag and drop this file to pico
 +
 +
## For setup the Board in thonny </b>
 +
* Stack Raspberry Pi Pico on the female header of Pico Sense HAT.
 +
* Connect USB cable on Raspberry Pi Pico USB port.
 +
* Choose interpreter as MicroPython (Raspberry Pi Pico).
 +
 +
[[File:Thonny-interpreter.PNG|600px]]
  
 
== Resources ==
 
== Resources ==
 
<b> Github </b>
 
<b> Github </b>
 
* [https://github.com/sbcshop/1.3-inch-LCD-Breakout.git Source Code]
 
* [https://github.com/sbcshop/1.3-inch-LCD-Breakout.git Source Code]

Revision as of 12:50, 17 January 2022

1.3inch LCD Breakout

1.3” LCD breakout is a 1.3-inch diagonal display with 240 x 240 resolution, 65K RGB colors, clear and colorful displaying effect, Four Push buttons, and a joystick. The 1.3" LCD breakout includes an integrated ST7789VM display driver and SPI interface, reducing the number of IO pins required.

Features

  • 1.3inch diagonal, 240x240 resolution, with embedded controller, communicating via SPI interface.
  • SPI interface, requires minimum GPIO for controlling.
  • Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/ Arduino/STM32).

Specifications

  • Operating Voltage - 3.3 V
  • Pixels - 240x240 resolution
  • Pixel Size - 0.0975 (H) x 0.0975 (V) mm
  • Display Driver - ST7789VM
  • Display Color - 65K RGB
1.3 LCD Breakout
Buy it From : Click Here

Installation

  • 1.3inch LCD breakout Module for microcontrollers eg: Raspberry Pi, Arduino, and raspberry pi pico, etc. it has, 65K Colors, 240×240, supports SPI protocol

In this folder, you see two python files and one firmware.uf2 file

* st7789.py -> this file contain the library of the LCD module, save the file in the raspberry pi pico
* main.py   -> this file contain the main code, you need to run this file, you also need to save this file to Pico
* firmware.uf2 -> by pressing bootsel of the pico and hold then connect to the laptop after this a new storage device comes, name "RPI-RP2", then  drag and drop this file to pico

    1. For setup the Board in thonny
  • Stack Raspberry Pi Pico on the female header of Pico Sense HAT.
  • Connect USB cable on Raspberry Pi Pico USB port.
  • Choose interpreter as MicroPython (Raspberry Pi Pico).

Thonny-interpreter.PNG

Resources

Github