8-bit-level-shifter

From SB-Components Wiki

8 Bit Level Shifter Breakout

The 8-bit level shifter is an 8-bit non-inverting shifter breakout board with the powerful and compact IC TXB0108 and VCCA Voltage Range: 1.2V-3.6V and VCCB Voltage Range: 1.65V-5.5V that acts as a bridge between applications with differing source voltage and input-output voltage levels.

Features

  • VCC Isolation Feature – If Either VCC Input Is at GND, All Outputs Are in the High-Impedance State
  • Low power consumption
  • High conversion speed, up to 60Mbps in push-pull applications, up to 2Mbps in open-drain applications
  • Bidirectional automatic conversion, no direction control needed
  • OE Input Circuit Referenced to VCCA
  • Ioff Supports Partial-Power-Down Mode Operation

Specifications

  • VCCA Voltage Range: 1.2V-3.6V
  • VCCB Voltage Range: 1.65V-5.5V
  • Conditions of Use: VCCB>VCCA
  • Working Current: 30uA
  • Support Port: push-pull, open-drain
  • Conversion Speed: push-pull 60Mbps(MAX)\open-drain 2Mbps(MAX)
  • Working Temperature Range: -30℃~75℃
  • IC - TXB0108
  • Power Consumption - 4μA Max ICC

Pinout

Pinout Description
VA A-port supply voltage. 1.1 V ≤ VA ≤ 3.6 V, VA ≤ VB
VB B-port supply voltage. 1.65 V ≤ VB ≤ 5.5 V
OE Output enable, by default set to high
GND Ground
A1-A8 Input/Output 1-8, Referenced to VA
B1-B8 Input/Output 1-8, Referenced to VB

Installation

The TXB0108 device has two functional modes, enabled and disabled. To disable the device, set the OE input low (By default set to High using resistor R2), which places all I/Os in a high impedance state. Setting the OE input high will enable the device.

Block Diagram

  • Typical Application Block Diagram for TXB0108

Application Block Diagram

Reference Circuit

8bit level shifter ref ckt.jpg

Resources