Home-Automation-HAT

From SB-Components Wiki

Home Automation HAT

Home Automation HAT is a Home monitoring and automation controller HAT for the Raspberry Pi that can control up to 2 appliances/devices on a load of 250 VAC/7A, 30 VDC/10A, photo-coupling isolation Optocoupler EL357NC, allowing users to safely control high voltages or current devices. Home-Automation HAT makes appliances smart, which users can operate via the PiRelay app on their electronic device.

Features

  • Compatible with Raspberry Pi 4, 3B+,3,2,Zero
  • Relay Status Indicator
  • Comes With Development Resources, including examples in Python
  • COM, NO(Normally Open) & NC(Normally Closed) are available for each relay
  • Connectivity of Relay With RPi Without GPIO
  • Connectivity Using Stack Method
  • Onboard Power LED Indicator
  • Make Your Home IoT Enabled
  • Relay Control Pins Selection Jumper

Specifications

  • Operating Voltage - 220V AC (Via Terminal Block)
  • External Load - 250 VAC/7A, 30 VDC/10A
  • Relay Channels - 2
  • Trigger Signal - 3.3/5V
  • Optocoupler - (CTR: 50~600% at IF= 5mA, VCE = 5V)
  • External Power Supply - Via Terminal Block
  • GPIO - 40 Pins Stacking Header
  • Load Connector - Screw Terminal Block for each Relay(Output)
File:Home-auto-hat.png
Buy it From : [ Click Here]

Pinout

Relays BOARD BCM
Relay 1 35 GPIO 19
Relay 2 33 GPIO 13

Installation

Raspberry Pi (Using PiRelay APP)

PiRelay is an Android app you can use to Switch or Pulse the GPIO Pins of a Raspberry Pi connected to Relays. To use this app you will need to setup your Raspberry Pi and Relays. App Download link:

  • To setup PiRelay on Raspberry Pi, run the below command one by one. Must complete all commands to make it work with Raspberry Pi.

Commands to Install: WiringPi, Apache, PHP & Download the GPIO PHP File

Resources

Github