Pico-wifi-HAT

From SB-Components Wiki

Revision as of 11:51, 26 August 2021 by Sbcshop (talk | contribs)

Pico Wi-Fi HAT (Incomplete Wiki)

Pico Wi-Fi HAT is a compact and easy-to-use Wi-Fi HAT for the Raspberry Pi Pico that includes an ESP8266 module, IEEE 802.11b/g/n Wi-Fi Standard, 3.3 V Operating Voltage, UART Communication interface, and a 40-pin GPIO extension header that can be controlled via AT Command and supports TCP/UDP communication protocol.

Pico Wi-Fi HAT also includes a 1.14-inch display with a resolution of 240 x 135 pixels, 65K RGB colors, and a sharp and vivid exhibiting effect, designed primarily for user engagement via SPI connection by incorporating a GPIO header. The 1.14-inch LCD includes the ST7789 Driver and SPI Interface, decreasing the amount of IO pins required.

It's a simple way to enable Wi-Fi on the Raspberry Pi Pico, making it suitable for a variety of IoT communication projects. It is intended for developers of all skill levels, from the most experienced to those who are just getting started with IoT devices.

Features

  • ESP8266 module with four-layers process
  • Standard Raspberry Pi Pico 40-pin GPIO extension header
  • Supports STA, AP, and STA+AP three Wi-Fi operating modes, embedded LWIP protocol stack, supports TCP/UDP communication
  • 2x functional buttons
  • Comes with development resources and manual

Specifications

  • Operating Voltage - 3.3 V (Internally connected on Pico 3v3 pin)
  • Communication - UART Interface
  • UART BAUD RATE - 115200 bps
  • Wi-Fi Standard - IEEE 802.11b/g/n
  • Frequency Range - 2400 ~ 2483.5 MHz
  • Wi-Fi Operating Mode - Wi-Fi STA, Wi-Fi AP, Wi-Fi STA+AP
  • Protocol - TCP, UDP
  • Antenna - PCB Antenna
  • Operating Temperature - -40℃ ~ 85℃

Pinout

Installation

MicroPython

  • Stack Pico Wi-Fi HAT with Raspberry Pi Pico.
  • Now Run Hercules Setup Utility and select tab TCP Server, enter port number as 8080 (you can choose any other port as well) and finally click on Listen button to start the TCP server on your PC/Laptop. Note down your PC/Laptop IP address to access your TCP Server.

TCP server start.PNG

  • Make sure to connect your PC/Laptop and Pico Wi-Fi HAT on same router. For example: If your Wi-Fi SSID is "TEST" and password is "test1234", then you must connect both device on TEST network.

Resources