Pi-Finger

From SB-Components Wiki

Pi-FInger

nents. PiFinger, the first-ever Fingerprint HAT for Raspberry Pi Comprise of onboard Nuvoton MCU with an on-chip crypto-accelerator, Cortex-M23 TrustZone, and XOM facilities. A user can use the communication protocol to the PiFinger with commands over the UART protocol with the Baud rate 115200 bps or USB 2.0 full speed.

Features

  • Capacitive Contact Technology
  • On Chip-Crypto Accelerator
  • High-Speed UART Interface
  • Register up to 24 Fingerprints
  • Nuvoton MCU
  • Cortex-M23 Trust zone

Specifications

  • Processor - Nuvoton MCU Cortex M23
  • Communication - UART, USB 2.0 and GPIO
  • Display - 0.91” OLED (SSD1306)
  • Buzzer - Yes
  • Default Baud Rate - 9600 bps
  • Matching Mode - 1:1,1:N
Air Monitoring HAT
Buy it From : Click Here

Pinout

PiFinger Raspberry Pi
VCC 5V
GND GND
Fingerprint TX GPIO15 (RXD)
Fingerprint RX GPIO14 (TXD)
OLED SDA GPIO2 (SDA)
OLED SCL GPIO3 (SCL)
BUZZER GPIO13

Installation

Python

Required Hardware
  • Raspberry Pi x 1
  • Pi-Finger x 1
Enable I2C and Serial Interface
  • Open a terminal and run the following commands to enable I2C:
sudo raspi-config

Choose Interfacing Options -> I2C ->yes

  • Again run below command to enable Serial
sudo raspi-config

Choose Interfacing Options -> Serial -> No -> Yes

  • You can also enable Serial and I2C using Graphical method, Open Menu by clicking on Raspberry Pi icon >> Preferences >> Raspberry Pi Configurations >> Interfaces , and select below option.

Serial i2c en graphical.PNG

  • Now reboot your pi by running the below command :
sudo reboot
Board Test
  • Connect PiFinger on top of 40 pins stackable GPIO header of Raspberry Pi.
  • Now Clone/Download PiFinger Repository by running below command or directly download from Github.
git clone https://github.com/sbcshop/PiFinger.git
  • Open cloned/downloaded folder and choose your environment type (i.e: Raspberry Pi or Windows)

For Raspberry Pi

  • Run PiFinger GUI by running the below command:

python3 PiFinger_GUI.py or using any python3 supported ide.

Select COM port and Baud Rate ( default is 9600) from the above GUI ("/dev/ttyS0" in case of default connection), and click on connect button to start communication with the fingerprint sensor.

For Windows

  • Run PiFinger GUI by running "PiFinger_GUI.py" file with any python3 supported ide.
  • Select COM port and Baud Rate ( default is 9600) from above GUI ("COM7" (check comport from device manager) in case of default connection), and click on connect button to start communication with the fingerprint sensor.

Resources

Github

Datasheet