USB-Fingerprint

From SB-Components Wiki

Revision as of 12:27, 26 October 2021 by Sbcshop (talk | contribs) (Created page with "<div class="row"> <div class="large-8 column"> == RFID Breakout == USB Fingerprint board is a board comprise of an onboard Nuvoton MCU with an on-chip crypto-accelerator, Co...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

RFID Breakout

USB Fingerprint board is a board comprise of an onboard Nuvoton MCU with an on-chip crypto-accelerator, Cortex-M23 TrustZone, and XOM facilities in a USB form-factor. A user can use the USB Fingerprint board with a PC or micro-controller with the Baud rate of 9600 bps or USB 2.0 full speed over the serial UART interface.

Features

  • USB / UART Interface
  • Capacitive Contact Technology
  • On Chip-Crypto Accelerator
  • High-Speed UART Interface
  • Register up to 24 Fingerprints
  • Nuvoton MCU
  • Cortex-M23 Trust zone
  • High-performance fingerprint algorithm
  • Register at most 24 fingerprints
  • High comparison speed
  • Matching mode 1:1; 1:N

Specifications

  • Sensor - Capacitive Chip Sensor
  • Active sensing area - 8.8 x 8.8 mm
  • Scanning speed - 25 Frame/ sec
  • Image resolution - 508dpi
  • Gray level - 8 bits/pixel, max 256 grayscales
  • Image ratio to width - 1:1
  • Operating Temperature - (20 ~ 60 ℃)
  • Operating humidity - 0 ~ 90% Non-Condense
  • Matching Mode - 1:1; 1:N
  • Sensor Coating surface color - Black Matte
USB Fingerprint
Buy it From : Click Here

Installation

Raspberry Pi

Resources

Github